159彩票

Recommended solution

  • Leader LD128EN (M) host reports failure

  • Common faults of fire engine and troubleshooting

  • Common faults of fire engine and troubleshooting

  • Fire engine full circuit fault detection

Mainframe repair

What should I do if the Lida LD128EN (M) host reports a fault and cannot reset it?

Author: YEAGO Beijing Fire Engineering Add Time: 2019-11-27 14:53

Lida LD128EN (M) host is a small wall-mounted fire alarm controller. If the fire alarm controller reports a fault, it cannot be reset. You need to check which part of the device reports the fault, and record the type and address code of the device. And replace the equipment. The fault on the fire alarm controller will not disappear until the faulty device is replaced.
Then perform the reset operation of the fire engine. You need to enter the operation password when performing the reset operation. Leader LD128EN (M) host factory password is 3 right arrows.